REACH RS+ RTK GNSS Receiver to use as a BASE STATION and for GCP
of DJI Phantom 4 adv | pro and Teokit
DJI PHANTOM 4 TEOKIT PPK
20 Mpx camera 26 minutes flight time Instantly ready to fly
BUILT IN GNSS BOARD
Teokit support Emlid Reach M+ board. The best and cheapest L1 solution for DJI Phantom 4
REMOVABLE GNSS SPIRAL ANTENNA
Our Spiral GNSS L1 antenna is highly sensitive. Is mounted in the center of DJI Phantom 4. Quick and easy removable.
CAMERA LENS CALIBRATION
To get perfect accuracy, you need to apply one GCP autocalibration mode in the software (Metashape, Pix4D, etc).
AShot controls "DJI Can Bus" and read Camera info, settings like Shutter etc, it also reads the Sony Sensor Bus to get the Exposure start and the Exposure end. That all allows AShot giving Timemark in the middle of Exposure without delay
The best PRE processing software for calculating the offset of the antenna relative to the camera when the copter is tilted. Link for download: http://teodr.one/cdn/soft/
Auto Shot Camera Control.
- make photos every 1.2 and 1.7 sec. without missing any ( DJI SDK has 3-4 photos passes per evry 100 photos ).
- powers Reach M+ module with good and stable voltage +5v.
- sends timemarks to Reach M+ in the middle of Shutter without delay.
With AShot board and Reach M+ installed to DJI Ph4 pro we make survey maps with 5-6 cm plan error and 6-8 cm altitude error without GCPs.
Teoboard is the heart of Teokit
Teoboard is the heart of Teokit:
GNSS signal distribution board from the spiral antenna to the Reach M + and DJI GPS module. A unique solution that allows you to have a constant high-quality signal of the GPS and GLONASS satellite constellations. Get high quality RAW satellite measurement data always, regardless of the weather and time!
- control of the number of tags and photos;
- filtering extra photos;
- calculate for camera coordinate offset due to the tilt of the copter;